Overview

Output summaries contain the ability to navigate between different loading combinations or members and summarize them. The below navigation only applies to summaries in the “Analysis Results” tab of the program. There are multiple filters that can be found on the each summary, below is the a brief description of each.

Members & Design Strips

Open

Member & Design Strip Selection

Depending on the wall file there may be zero, one, or two options as shown above. Filters of this kind can be found on all of the following summary tabs:

• Design Parameters

• Loading Summary

• Stripping

• Transportation

• Erection

• Secondary Erection

• Load Case Results

Load Combinations, Analysis Points & Members

Open

Load Combinations, Analysis Points, and Members Selection

Depending on the wall file there may be 8, 7 or 6 options. In this selection the Load Combination can be specified or set to use all combinations, in addition to setting the Load Combination loading types may be selected as well (i.e. A load combination is specified however “Wind Load” is set to only show pressure cases). Analysis points may also be specified here to allow for each section to be considered. As with the member and design strip selection, if desired the member and design strip can be specified as well. Filters of this kind can be found on all of the following summary tabs:

• Detailed Flexure Capacity

Load Combinations & Members

As with the above section this selector allows for fine tuning of the results to get the exact summary results desired. If applicable, members and design strips may also be filtered here. Filters of this kind can be found on all of the following summary tabs:

• Strength Results

• Service Results

• Horizontal Shear