Table of Contents | ||||
---|---|---|---|---|
|
v4.14.0 -
Fixed an issue where the eccentricity input in non-symmetric sandwich panels was not reported correctly.
Updated the calculation method for partially composite panels. Camber and cracked section properties are now interpolated between fully composite and non-composite cases.
Allowed negative elevation input for concentrated loads.
Resolved a bug that could cause incorrect quantities of face lifters during the stripping phase.
v4.13.3 -
Updated the lifter reaction value to be unfactored, as reflected on the summary page.
Resolved an issue where the phi value was not correctly reported.
Fixed a bug that incorrectly set the cantilever deflection limit to 0.
v4.13.2 -
Fixed an issue of wind loads with different start and end magnitudes resetting when reopening the file.
Fixed an issue where strand eccentricity is causing deflections in the incorrect direction.
The issue of incorrect prestress losses in Asymmetric Panel using the Time Dependent method has been resolved.
The issue of incorrectly reported flexural utilization when the user inputs mesh in the top wythe in Asymmetric panel has been fixed.
The issue of beam-spring design only displaying errors for a single wythe and not allowing swapping to the other wythe has been resolved, now displaying warnings for both wythes.
The issue with edge lifter capacity being checked incorrectly has been resolved.
v4.13.1 -
Fixed an issue with lifter location warning.
Fixed an issue with asymmetric beam-spring panels moment calculation.
v4.13.0 -
Added coefficient of thermal expansion on structural model.
Fixed issue with printing beam-spring files.
Analysis should now abort with a warning when analysis appears to be unstable.
Fixed issue with keyboard short cuts firing wrong command.
Improved stability when working with multiple files.
v4.12.0 -
Improved stability when working with multiple files.
Fixed issue where the loading datum, for percent composite panels, could be stuck using the deflection section.
Fixed issue that could turn the bottom pin into a roller.
Added keyboard shortcut (Ctrl+Shift+R) to run the handling analysis.
Added a warning for if prestress is below 225 psi.
Add checks for if geometry appears valid.
v4.11.1 -
Fixed issue with summary selectors not updating on Strength and Service Summary tabs.
Fixed issue where the loading datum, for percent composite panels, could be stuck using the deflection section.
v4.11.0 -
Horizontal shear summary UI updated. Fixed issue where shear zones would not be added next to lifters correctly
The “Analysis Results” section is now called “Analysis Report”
The “Load Case Results” section is now called “Analysis Results”
The now “Analysis Results” section changed as follows
Added a section showing the combination envelopes for both strength and service combinations
Added a section summarizing kl/R for each span
Added a section summarizing the second order effects and how much they increased your demand (for strength).
Default lifters now correctly save to disk
Miscellaneous bug fixes
v4.10.0 -
Added Design Strips to the Structural Model input tab.
Added Slender Wall calculations from ACI 11.8 to the Design Criteria input tab.
This option can be found in Settings/Structural Analysis/2nd Order Effects
Output summaries now contain filtering options for load combinations and patterns if applicable for more finetuning and easier viewing of design strips.
Misc. bug fixes.
v4.9.5 -
Fixed issue with shear near ends reporting 0 capacity.
Fixed issue with flexure reporting 99 utilization when demand was 0.
v4.9.4 -
Fix label on concentrated loads not updating when datum changed.
Tweaked tolerances to fix convergence issues.
...