Page Comparison

v1.4.5

• General analysis

  • In very rare cases a lift position may overlap with a point in the analysis causing bad values in the analysis. This update fixes this case.

v1.4.4

• Performance Summary

  • Fixed a bug where high values of concrete strength would cause an issue in the Performance Summary PM Diagram

  • Fixed a bug where losses would not use the “Specify” even if the option was selected

v1.4.3

• Performance Summary

  • Added and Analysis Option to toggle where the prestress is applied (Allowable vs. Demand)

...

• In the handling stages this Analysis Option will change the layout of the demand and allowable values

...

• Piece Ticket

  • Misc. fixes to the piece ticket output

• Main Window

  • Print All now asks what you would like to print

• Program Options

  • A new option was added to specify what number format the program will use (periods or commas as decimal points) in the option “Number Format”

    Image Added

• Bug Fixes 🐛

  • Issue where some countries would experience crashes due to mismatched windows cultures not be appropriately handled.

  • Countries where a comma may be used in lieu of a period for decimal points would cause crashes

v1.4.2

• Bug Fixes 🐛

  • Piles with only rebar reinforcement had drawing issues in the production summary, reinforcement tab, and the piece ticket.

  • Piles with only rebar reinforcement would crashed the program when using the Detensioning tool in the piece ticket.

  • Piles with only rebar reinforcement would display NaN for the allowable in the handling stages.

  • Piles with only rebar reinforcement would not display the interaction diagram in the Analysis summary.

v1.4.1

• Bug Fixes 🐛

  • Fixed a drawing issue where the Reactions could be too close together to show a distance in the Moment/Reaction diagram.

  • Fixed a drawing issue where the “M” label in the Moment/Reaction diagram would overlap a line.

  • Fixed a bug in the lifter utilization check that caused an error to be reported even if there were no lifters being checked.

v1.4.0

• Analysis Summary

  • Fixed a bug where rolling block lifts were being performed as static lifts in certain situations.

  • Added interactive Moment/Reaction diagrams for all handling stages.

• Handling Input

  • Fixed a bug where top edge lifters were not being loaded on file open.

  • Added static lift support for the Erection stage.

• General

  • Added more warnings and errors when checking lifting capacities.

  • Added a warning to flag for possible invalid lifting configurations if a lifting reactions is in compression.

v1.3.7

• Performance Summary

  • Fixed a bug in the lifting stages where if the stress was over the tension allowable it would not be flagged.

• Production Summary

  • Fixed a visual bug where rebar would always be shown on the cut section even if no rebar was present.

...