This tab covers the reinforment input panel.
Strand Properties
In this block, you enter all information that sets the strand properties. Depending on which of the section types are selected, the input content will change. The inputs for this section are:
Header | Description |
---|---|
Size | The size of the strand used. |
Area | The area of the strand used. This is only editable if Size is set to “Custom” |
Diameter | The diameter of the strand used. This is only editable if Size is set to “Custom” |
% Pull | The percent pull on the strand typically 70-75%. |
Strand Pattern
In this block, you enter all information relating to the strands pattern in the concrete. Depending on which of the section types are selected, the input content will change. The inputs for this section are:
Header | Description |
---|---|
Pattern Type | Either Circular or Rectangular. This input determines what fields are in the strand pattern table below. |
Automatically Set Covers | If enabled sets the strand to be directly inside the transverse reinforcement. |
Strand Pattern Table (Rectangular) | Sets the outermost border of a defined rectangle of x rows and y columns. For example, if there were 4 rows and 4 columns the outer 12 strands would be shown. The edge distances are from outer edge of the pile to the center of the strand. Edge Distances cannot be edited if “Automatically Set Covers” is checked |
Strand Pattern Table (Circular) | Sets a circular pattern of strand around the pile a set distance in from the pile edge (Edge Distance). The count is the amount of strand in the pattern and the offset is the degrees the strand are offset from their original positions moving counter-clockwise. Edge Distance cannot be edited if “Automatically Set Covers” is checked |