Table of Contents | ||||||||
---|---|---|---|---|---|---|---|---|
|
v5.4.3 -
Fixed an issue with adding openings to the beam design file.
v5.4.2 -
Fixed an issue where the Weight of Participants input would reset for vibration check.
Added the total beam weight display at the top of the handling input section.
v5.4.1 -
Resolved an issue where the critical flexure case might not be included in the report.
Fixed a bug causing 'distributed loads' option to affect area load results when they shouldn't.
Addressed an issue where the critical Mu value might not appear on the design summary page.
Added an option to input additional result points in feet and inches format.
Introduced a new input scheme for riser sections.
Enhanced the program’s ability to notify users when a newer version is available.
v5.4.0 -
Fixedthe "Ignore left/right cantilever loading" option now reports results correctly.
Resolvedan issue in vibration design where the total weight was incorrectly reported.
Corrected an issue of required steel using the Zia-Hsu method.
UpdatedPCI losses now account for elastic gains due to superimposed dead loads.
Fixed a bug that prevented the summary graph from displaying correctly when printed to PDF.
v5.3.2 -
Resolved an issue where user-defined additional output points were not appearing in the results table.
Fixed a bug that caused the geometry limit to be reported incorrectly.
v5.3.1 -
Added the option to use Stress Relieved strands.
Corrected an issue where incorrect moment was reported under detailed flexure capacity.
Fixed a bug in the calculation of the neutral axis depth for asymmetric members, which was previously computed too low.
Resolved a crash caused by fixed ends analysis.
Addressed a problem where the Acr value was reported incorrectly.
Fixed the fillet and chamfer input issue.
Corrected an issue where shear fy was set to 0 if transverse reinforcement existed at a location but was not used for shear.
Added color to more demand capacity ratio graphs.
...