Reinforce Part provides settings to configure how reinforcement information should be passed from the design file to parts in the model. The settings control which types of reinforcement to remove from the model, which types of reinforcement to insert into the model and how to place inserted reinforcement.
| Table of Contents |
|---|
Removal Settings
...
Before reinforcement is read from a design file and inserted into a part in the model existing reinforcement can be removed or left in place. Whether reinforcement should be removed or not can be set individually for rebar, mesh, strand and stirrups.
...
Each option has a selection for the method and an input for the precision to use. Precision is the number of places to the right of the decimalvalue you want to round to (such as 0.125 if you want values rounded to an 8th of an inch).
...
There are six methods for rounding:
None will do no rounding and use exact calculated values.
Round will use typical rules for rounding a value up or down.
Round down will always round down to the specified precision.
Round up will always round up to the specified precision.
Away from the nearest end will locate the nearest end and then round so the new location is further from it.
Towards the nearest end will locate the nearest end and then round so the new location is closer to it.