Table of Contents | ||||
---|---|---|---|---|
|
v4.14.0 -
Fixed an issue where the eccentricity input in non-symmetric sandwich panels was not reported correctly.
Updated the calculation method for partially composite panels. Camber and cracked section properties are now interpolated between fully composite and non-composite cases.
Allowed negative elevation input for concentrated loads.
Resolved a bug that could cause incorrect quantities of face lifters during the stripping phase.
v4.13.3 -
Updated the lifter reaction value to be unfactored, as reflected on the summary page.
Resolved an issue where the phi value was not correctly reported.
Fixed a bug that incorrectly set the cantilever deflection limit to 0.
v4.13.2 -
Fixed an issue of wind loads with different start and end magnitudes resetting when reopening the file.
Fixed an issue where strand eccentricity is causing deflections in the incorrect direction.
The issue of incorrect prestress losses in Asymmetric Panel using the Time Dependent method has been resolved.
The issue of incorrectly reported flexural utilization when the user inputs mesh in the top wythe in Asymmetric panel has been fixed.
The issue of beam-spring design only displaying errors for a single wythe and not allowing swapping to the other wythe has been resolved, now displaying warnings for both wythes.
The issue with edge lifter capacity being checked incorrectly has been resolved.
v4.13.1 -
Fixed an issue with lifter location warning.
Fixed an issue with asymmetric beam-spring panels moment calculation.
v4.13.0 -
Added coefficient of thermal expansion on structural model.
Fix Fixed issue with printing beam-spring files.
Analysis should now abort with a warning when analysis appears to be unstable.
Fixed issue with keyboard short cuts firing wrong command.
Improved stability when working with multiple files.
v4.12.0 -
Improved stability when working with multiple files.
Fixed issue where the loading datum, for percent composite panels, could be stuck using the deflection section.
Fixed issue that could turn the bottom pin into a roller.
Added keyboard shortcut (Ctrl+Shift+R) to run the handling analysis.
Added a warning for if prestress is below 225 psi.
Add checks for if geometry appears valid.
...