...
When reinforcing parts in the model options can be set for which types of reinforcement to insert and how each should be placed. Each type of reinforcement (strand, rebar, mesh and stirrups) has its own settings available on its own page.
...
Insert Reinforcement
At the top of each page is a checkbox that if checked will insert that type of reinforcement from the design file into the model when Reinforce Part is run. Removing the check mark ensure ensures that Sync does not place that type of reinforcement into the model.
...
Each option has a selection for the method and an input for the precision to use. Precision is the value you want to round to (such as 0.125 if you want values rounded to an 8th of an inch).
...
None will do no rounding and use exact calculated values.
Round will use typical rules for rounding a value up or down.
Round down will always round down to the specified precision.
Round up will always round up to the specified precision.
Away from the nearest end will locate the nearest end and then round so the new location is further from it.
Towards the nearest end will locate the nearest end and then round so the new location is closer to it.
...