Description
...
Once both evaluation points are known for each member the tool will compute hat functions at each corner point giving a value that can be used to calculate the offset at a given (x, y) location. Once the offset calculation is known using any offset point from the Family Instance points will allow for an angle to be found. These found values are placed in 4 parameters, 2 for each side of the Family Instance. The parameters that hold these values are set in the BIMpak Settings under Warping Tool Settings.
...
The Start of the member uses the Mark End Warp Offset and Mark End Warp Angle parameters for the offset height and warp angle respectively. The end of the member uses the Opposite End Warp Offset and Opposite End Warp Angle parameters for the offset height and warp angle respectively.
...