Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Table of Contents

v4.9.1.0

  • New Features / Improvements

    • Option to not check shear / torsion within critical distance. Checking this option will remove all locations from centerline location and critical distance from output.

    • Transverse steel now has user select which face the reinforcement is for. Previously it would put all reinforcement with a single leg on the interior face. Now the user selected what face the steel is for. Selecting both faces will put half on each face.

    • Can now add rows to tables if a design deficiency is present at that location. This option can be found under File → Result Points.

    • Construction stage for deflections now shows the deflections due to wet topping weight. This deflection does not include any long term creep effects.

    • Prestress losses on performance summary are now midspan losses instead of maximum.

    • The user can now selected the end zone length for the transfer stage. This option is found under Design Criteria → Transfer → End Zone Length

  • Bug Fixes

    • Multiple issues fixed with printing.

    • Fixed conservative issue with shear near the supports.

    • Tension graph now correctly graphs the selected load combination, not the controlling.

    • Fix intermittent issue resulting in topping load being cleared if it didn’t start at 0.

    • Fix crash when used draped strands.

    • Fix issue where the ‘Compute Topping Profile’ feature would crash.

    • Fix incorrect losses table when using user defined losses.

    • Help → Technical support should now work again.

v4.8.0.0

  • Load summary added to analysis report. This section summarizes all applied loads and all load.

  • Distributed load grid split into area and line load grids.

  • Added the torsion stress limits to the torsion tables.

  • Added plain concrete strength back for both flexure and shear as a minimum strength.

  • Topping stresses are now transformed.

  • Sustained compression tables will now always be visible.

  • Fix tables not being highlighted.

  • Combine summary and combination tabs

    • Both the service and strength section of the report now contain a single tab instead of two. On this tab the user can now select as many combinations as they want to be summarized.

  • Fix load patterning issue.

  • Nu / Vu ratio inputs now updated to correctly show that they use Nu to Vu sustained.

  • Multiple bug fixes.

...